> The screws are T-6 Torx; don't try to force them with something else, and DO
> NOT try to pry the back off the phone.
>
> Mark
Sorry that I'm not so hardware knowledgeable. Is T-6 Torx a readily
available screwdriver bit? If I went into any hardware store and asked for
that, would they have it?
Is it that little screw thing I was suspected on the back of the phone? Is
that what I need to unscrew with T-6 Torx?
Traveling Man - 18 May 2004 14:11 GMT
> Sorry that I'm not so hardware knowledgeable. Is T-6 Torx a readily
> available screwdriver bit? If I went into any hardware store and asked for
> that, would they have it?
Sears carrys them in a kit with several other sizes.
Robert M - 18 May 2004 14:29 GMT
> > Sorry that I'm not so hardware knowledgeable. Is T-6 Torx a readily
> > available screwdriver bit? If I went into any hardware store and asked for
> > that, would they have it?
>
> Sears carrys them in a kit with several other sizes.
T-8, T-10, and T-12 are needed for working on laptops.
>> What most often breaks is not the antenna, but the plastic bushing that
it
> screws into on the back of the phone. The antenna itself almost never
> breaks, but gets lost when the bushing snaps off. The entire back can be
> purchased or just the plastic piece that has the bushing on it.
As I mentioned, I ordered a replacement antenna on the net, which should be
coming in the next couple of days. Since it's that bushing that breaks, do
replacement antennas generally come with replacement bushings? If it's only
the antenna that comes, without the bushing, is that useless?
David L - 18 May 2004 12:19 GMT
> >> What most often breaks is not the antenna, but the plastic bushing that
> it
[quoted text clipped - 6 lines]
> replacement antennas generally come with replacement bushings? If it's only
> the antenna that comes, without the bushing, is that useless?
I replaced a V60T (ATT TDMA) model busing. So I don't want to confuse
anyone.
A #6 torx wrench is available on the net or Sears (so I've been told).
I've cheated and used a allen wrench before, but that's not
recommended since they are on pretty tight.
I basically had to almost disassemble the entire phone to replace the
"bushing", which the antenna screws into. There's quite a few steps
involved, with odd shaped plastic parts and small scews, so don't rush
or force anything!
What a POS design, as far as antenna replacement. Apparently, those
attractive replaceable aluminum cases, provide no structural integrity
for the antenna, so Motorola addded an easily breakable and difficult
to replace, plastic "bushing" assembly for the antenna to screw into.
Well, at least it can be renewed.
Use two pliers for unscrewing a small ring at the base of the "broken"
antenna, which is actually part of the "bushing" assembly which
broke...not the antenna.
The rest is deep inside the handset, at least on the V60T model.
Good luck!
-----
David